ECUTek Logs
 

After some ECUTek idle logs of any non F.I 370. Trying to compare some figures to mine.

Also, is there anyway to set a default parameter list to record? Everytime I open a new ROM have to go through the list and pick what I want logged.

I can take some idle logs for you. What parameters do you want?

Great! At work at the moment, so can't remember exactly names but I'll give it a shot. Around 2 minutes from a cold start would be awesome.

After MAF 1&2 voltage + MAF flow (g/s) + AFR Bank 1&2 + Heater (O2s) 1&2 + Throttle Position Sensor 1&2 + Engine RPM.

I'm non Fast Intentions (sarcasm, never know what flys over people's heads these days) so I can help if your looking for multiples.

Curious what you are looking to get from these logs?

I'm having issues with this Stillen SC setup. But I'm not sure why. My issues seem isolated to Bank 2 (Cylinder 2, 4 & 6). I have the Stillen Intake Manifold, so air is shared going in... but my AFRs on Bank 2 are giving me nothing but grief. Replaced AFR sensor Upstream & O2 Sensor Downstream. No change.

Recently blew out the Bank 2 Cat. Even after replacing the O2 Sensor, ECUTek is now no longer seeing anything for either Heater Circuit, Bank 1 or 2 (stuck on 0.28v).

In addition I'm getting a really bad jerking when in low RPM & under load, say cruising uphill.

Photos attached of the AFR readings I'm getting, this was just relatively cold-start and idle for a short while. This is driving me absolutely nuts. Can't finish tuning the damn thing till I figure this out. I'm starting to wonder if I have shitty injectors... but it seems weird that it's only limited to just one bank? :(