Nissan 370Z Forum - Upgrade 14'' 2-piece open slot rotor direct bolt on with your (Akebono caliper)

Page 3 of 3

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Suspension/Brakes (http://www.the370z.com/suspension-brakes/)

- - Upgrade 14'' 2-piece open slot rotor direct bolt on with your (Akebono caliper) (http://www.the370z.com/suspension-brakes/65903-upgrade-14-2-piece-open-slot-rotor-direct-bolt-your-akebono-caliper.html)

RacingBrake

02-04-2013 06:52 PM

Bump ...

RacingBrake

02-07-2013 01:15 PM

Bump ...

RacingBrake

02-08-2013 06:59 PM

Bump ...

Imperial

02-11-2013 04:26 AM

Do these require any grinding of the dust gaurds for proper fitment? Would you guys be able to install these for someone local?

DEpointfive0

02-11-2013 04:50 AM

Quote:

Originally Posted by Imperial (Post 2159082)

Do these require any grinding of the dust gaurds for proper fitment? Would you guys be able to install these for someone local?

Two-piece rotor (Open Slot) - 370Z (Sport) REAR 09-11

"Installation note:

Trim the back plate edge approximately 2-3mm (0.1") to avoid interference with the rotor hardware."

RacingBrake

02-11-2013 11:31 AM

Hi, both back dust guards need to be grind for better fitment. We don't do installation here, I can recommend a shop call Renner Motorsports in Inglewood the owner name is Ivo. Below is the address of his shop.

Renner Motorsport
324 W. Florence Ave
Inglewood, CA 90301
Tel. 310 673 8492

Imperial

02-14-2013 02:59 AM

Quote:

Originally Posted by DEpointfive0 (Post 2159091)

Two-piece rotor (Open Slot) - 370Z (Sport) REAR 09-11

"Installation note:

Trim the back plate edge approximately 2-3mm (0.1") to avoid interference with the rotor hardware."

Too bad. I don't consider anything that requires grinding to be "Bolt-On"

RacingBrake

02-14-2013 04:54 PM

RB 2-piece rotor

Quote:

Originally Posted by Imperial (Post 2164469)

Too bad. I don't consider anything that requires grinding to be "Bolt-On"

If you don't like grinding, removing the back plate is also an option.

All times are GMT -5. The time now is 10:52 PM.

Page 3 of 3

Show 40 post(s) from this thread on one page