Nissan 370Z Forum  

Go Back   Nissan 370Z Forum > Search Forums


Showing results 1 to 25 of 30
Search took 0.00 seconds.
Search: Posts Made By: A4RingedONE8T
Forum: Forced Induction 07-25-2011, 09:51 AM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
MAP sensors run on 0-5v just as the MAF's do. You...

MAP sensors run on 0-5v just as the MAF's do. You could most likely remove the MAF's and replace them with MAP on the stock ECU and with the proper tune it should work. You'd have to add a separate...
Forum: Forced Induction 07-21-2011, 01:34 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Bridged the IAT and MAF +'s, using the signal...

Bridged the IAT and MAF +'s, using the signal from the passenger side (lower reading) MAF. First starting the car, the a/f's seem much better than previously, now around 14.6-15.5 sweeping at idle
Forum: Forced Induction 07-21-2011, 12:50 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
I can't get a meter on the harnesses with them...

I can't get a meter on the harnesses with them plugged in, I don't want to strip any wires yet

Here's the info had from probing the harnesses, ignition on, MAF's unplugged

Pass side

Pin 2...
Forum: Forced Induction 07-21-2011, 11:22 AM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
I haven't taken a meter to it because both MAF...

I haven't taken a meter to it because both MAF signal and IAT signal are 0-5v, no way of distinguishing between the two. The car is very (tuning) dependent upon the MAF signals, I'm not going to...
Forum: Forced Induction 07-21-2011, 10:43 AM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Assuming the connector diagram (view) above: ...

Assuming the connector diagram (view) above:

Pin 1 - not used on either MAF

Color codes as follows:

Driver side MAF

Pin 1 - not used
Pin 2 - Grey
Forum: Forced Induction 07-21-2011, 10:19 AM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
I also found a similar diagram however it is not...

I also found a similar diagram however it is not the correct one, nor is yours. The pins and colors do NOT correspond with what's on Ryan's car.
Forum: Forced Induction 05-20-2011, 05:08 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
A text from Ryan earlier when I asked him what...

A text from Ryan earlier when I asked him what they were doing

"Out doing the poker run with the GoPro"

I think your wishes will be granted ;)
Forum: Forced Induction 05-20-2011, 04:57 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
A little birdie told me there was a single turbo...

A little birdie told me there was a single turbo 370Z tearing up the mountain roads up in NC all day today!! :driving:
Forum: Forced Induction 05-19-2011, 08:37 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Ryan is on his way to NC! Got the car back...

Ryan is on his way to NC!

Got the car back in this morning, luckly found two Flex-a-lite fans local and went to town today! Replaced the OEM fans with a 16" 2300cfm and a 10" 1800cfm. The smaller...
Forum: Forced Induction 05-16-2011, 09:08 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Got Ryan's car back in today, moved the oil...

Got Ryan's car back in today, moved the oil cooler to the front and made a shroud to direct air into it through the rather small grill openings in the bumper. Pulled the turbo and wrapped the...
Forum: Forced Induction 05-13-2011, 08:22 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Stock MAF's should be maxing out around 10-12psi,...

Stock MAF's should be maxing out around 10-12psi, the passenger side MAF, on the radius, is NOT the problematic one. The one on the DRIVER'S side, the one on the straight piece of pipe, is the one...
Forum: Forced Induction 05-12-2011, 08:39 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Here's the 4.8psi graph ...

Here's the 4.8psi graph

http://i19.photobucket.com/albums/b156/a4ringedone8t/7d6fe83e.jpg

I just noticed the dotted line is the stated numbers, hp looks about 10-15 higher, closer to 440ish and...
Forum: Forced Induction 05-12-2011, 08:31 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Here's a vid from my iPhone ...

Here's a vid from my iPhone

http://s19.photobucket.com/albums/b156/a4ringedone8t/?action=view&current=3a847cd2.mp4
Forum: Forced Induction 05-12-2011, 07:10 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Problems solved, 428whp @ 4.8psi, boost going up...

Problems solved, 428whp @ 4.8psi, boost going up as we speak!
Forum: Forced Induction 05-11-2011, 11:55 AM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
She's done, ready for tuning tomorrow! ...

She's done, ready for tuning tomorrow!

http://i19.photobucket.com/albums/b156/a4ringedone8t/Speed%20Freak%20Fabrications/IMG_6331R.jpg
...
Forum: Forced Induction 05-09-2011, 08:46 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Engine bay is done! ...

Engine bay is done!

http://i19.photobucket.com/albums/b156/a4ringedone8t/Speed%20Freak%20Fabrications/IMG_6312r.jpg
...
Forum: Forced Induction 05-08-2011, 08:15 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
lol what?

lol what?
Forum: Forced Induction 05-08-2011, 03:07 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Thanks! Here's my manifold/dp setup (the first...

Thanks! Here's my manifold/dp setup (the first turbo setup I built btw, 2 years ago)

http://i19.photobucket.com/albums/b156/a4ringedone8t/Turbo%20MCoupe/DSC09386R.jpg

564whp/470wtq @ 17psi on...
Forum: Forced Induction 05-08-2011, 02:51 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
My complete turbo setup was custom fabbed by me....

My complete turbo setup was custom fabbed by me. Exhaust is 3" downpipe (all that would clear the back runner of my exhaust manifold), tapers to 4" next to the gearbox and is 4" all the way back....
Forum: Forced Induction 05-08-2011, 08:26 AM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Single 3"? Ryan ... If we ever do you a single it...

Single 3"? Ryan ... If we ever do you a single it will be 4"!! And any rear can be modified for single, even my M which comes with quad tips!
...
Forum: Forced Induction 05-06-2011, 05:57 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Had some bad thunderstorms this afternoon and we...

Had some bad thunderstorms this afternoon and we lost power at 2pm, at 4 and no sign of it coming back I gave up and left so didn't go too much further. Hopefully finish up most everything on...
Forum: Forced Induction 05-05-2011, 09:16 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Thank you everyone for your comments and for your...

Thank you everyone for your comments and for your love of the build, it is greatly appreciated! 13 hours of work later today, it is farther than yesterday however didn't even get a chance for more...
Forum: Forced Induction 05-04-2011, 08:52 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Everything will be heat wrapped plus a turbo...

Everything will be heat wrapped plus a turbo blanket, Setrab 24 row oil cooler, and an extra quart of oil with the oil pan spacer, all should be good!



Not necessarily. I'm pretty sure this...
Forum: Forced Induction 05-03-2011, 08:48 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
This isn't a BMW :bowrofl: Yes, A/C is still...

This isn't a BMW :bowrofl: Yes, A/C is still fully in place!



Thanks Ryan, as many think otherwise, custom costs more than something from the shelf typically. Why people think it should be...
Forum: Forced Induction 05-03-2011, 04:47 PM
Replies: 1,279
Views: 224,443
Posted By A4RingedONE8T
Today's progress ...

Today's progress

http://i19.photobucket.com/albums/b156/a4ringedone8t/Speed%20Freak%20Fabrications/IMG_6213R.jpg
...
Showing results 1 to 25 of 30

 
Forum Jump

All times are GMT -5. The time now is 03:32 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2