Originally Posted by Cjanik (Post 173129)

it uses the stock wiring harness. I dont make anything up, this is all stuff straight from the factory, so its plug and play. if you have illuminated kick plates allready, there's just a plug you disconnect/reconnect about 1 foot from the kick panels. If you dont have them, then there's a stock plug you unplug, and then connect this new plug into (included in the kit) - and run 1 wire to the passanger side and 1 wire to the drivers side. From there, you plug the kickpanels into the wire you ran.

very easy, just zip tie the wires under the dash, or stick them behind the carpet (instruction manual that comes with it says to do that from nissan).