7AT to 6MT Swap Kit everything needed (Trans+everything else) Phoenix AZ 7K mi SOLD
 

SOLD
For sale is a "kit" of basically everything needed to swap your 7AT to 6MT w/synchro rev match.

Recently swapped my 2017 with 7K miles on it from 6MT to 7AT, so I have everything removed from the vehicle thats needed to convert 7AT to 6MT.

Included (everything has 7K miles on it, 2017)

1. ECU, BCM, set of 2 keys, fobgina and start/stop switch
2. Transmission w/synchrorev match. All sensors still installed
3. Driveshaft (not pictured)
4. Clutch and flywheel with bolts (basically new, machining lines still visible)
5. Clutch pedal w/switches
6. Clutch master cylinder with hardware, clutch lines & OEM CSC (see my other for sale thread for HD CSC, RJM pedal & HD master cylinder)
7. Brake pedal (narrower than the auto)
8. Shifter, all hardware and trim pieces
9. Various hardware/bolts for transmission
10. New driveshaft/output shaft seal (old seal is fine though)

The only thing missing is a PILOT BUSHING which can be had for $3 on Z1 or dealer.

Youtube HOW TO swap 7AT to 6MT
The only thing that I would correct from the above video: you don't need a tune or ECU programming if you use a 6MT ECU, BCM and KEYS all from the same vehicle. If you install all these together your car will start and drive perfect with no check engine light. Will need dealer to reprogram your VIN and TPMS sensors but will run and drive with no CEL even before the reprogramming.

Regarding the wiring. You can use your existing 7AT harness, you will just need to rewire the reverse lights, clutch switches, P/N switch and the synchrorev match (if you want it). The wiring shouldn't be too bad. If you want I can create wiring diagram on how to hook everything up for an extra $150 for the time and effort it takes to look at all the diagrams and draw up a diagram.

Located in Phoenix AZ. Pick up or I can deliver locally since I have a truck.

Only exception: If you schedule and arrange/pay for for LTL freight, I will agree to pallet everything up and drop off in Phoenix for shipping. The carrier needs to be able to accept a pallet. The driveshaft is long so might need to pay to ship that separate.

If you are interested in an HD CSC, HD master cylinder or RJM pedal I am selling those in my other thread. Will sell with this kit 35% off the price in that thread.

$2,500 for everything. Will not separate, all sold together. Thanks!!