One-off Titanium Charge Pipes
 

Last summer, a good friend and I embarked on project to play with titanium and see what was possible. I'm now looking to pass these on to someone that will appreciate them more than I do as my car sits 98% of the time.

These were hand-built using pie cuts and MAF flanges from TiCon. They are full length (2 pieces per side) and mate up perfectly to my Treadstone dual outlet intercooler. The driver's side has a bung machined and welded in for vacuum lines. I have run 12 pounds of boost through these without a single leak or slipped coupler.

There is $1,000+ in raw titanium and countless hours wrapped up in these. The couplers and clamps would not be included, but I could point you in the right direction to replicate my setup if desired. I'm assuming they could also be used as CAI's, but I can't make any promises or recommendations.

Price: $1,800 shipped

https://i.imgur.com/eKD3vqYl.jpghttps://i.imgur.com/67ntV05l.jpg

Very nice. How come you didn't decide to put a burn on them? I think that would look cool.