Lots of Goodies: Motordyne, Stillen, Soho Motorsports, Enkei Wheels,TBs
 

All items are located in Southern California Region. NO SHIPPING ON LARGE ITEMS SUCH AS EXHAUST AND EXTERIOR*Photos will be uploaded once all are removed from vehicle. Going back to stock for dealer. LoCal Pick up preferred. Text 9095499376 for quicker response

EXHAUST CLIP: https://youtu.be/VW8cCo8Q8M0

1.Stillen Front Fascia with Brake Duct Fangs, Mesh, and Splitter*Do note that this is a track and daily car. So there are lots of rock chips on the bumper. Mesh on outer edges were trimmed to fit DRLs(custom mounting kit not included for drls).RODS ARE INCLUDED. The end tips where the fender connects to bumper does show some stress cracking in the paint but if you're going to repaint the bumper a good shop should be able fix it. The splitter has taken a beating throughout it's use so it is somewhat warped and scraped. -Sold
Original price($1200+ with body work and accessories)

2. Motordyne Plenum signed by 370z designer Randy Rodriguez and FormulaD Drifter Chris Forseberg-SOLD

3. Motordyne Art Pipes-$SOLD(400 w/ OEM Cats/Test Pipes)

4.Motordyne Y Pipe Resonated-SOLD

5. Beluga Y-Back with custom dump pipe valve opener and switch-250$
Paid Price-$450


6. Injen Long Tube Intake replaced with 3 inch Spectre Air Filters (Modified to not taper at MAF section. Will need a tune after install)-SOLD

7.Soho Motorsports Ported Lower Intake Manifold-$]SOLD

8. Ported Throttle Bodies 63mm *Photo with green in center is oem-SOLD

9. Enkei RS05RR- Gunmetal Rim (Size: Front 18x10 / Offset: +22 / PCD: 5x114.3...Rear:Gunmetal 18x10.5 +15 5x114.3
3/4 Tires are like new. Rears are continental dws and front Lionhart. Not the best but better for the season
Price:SOLD
11. Fly1Motorsports Duckbill. *There is 2 small nicks on the rear and 2 small hairline scrapes that look like they were from rocks or an angry individual with a knife that slid it across. As you can see in the photos they are barely noticeable unless you're told about it or feeling it. Some sections have been touched up - SOLD

12. Fly 1 Carbon Side Blades(Short to allow mudguards)
Driver side has quarter size chip in the very front. Flex cracks in the inner edge due to flexing(noticeable only when upclose).Passenger side was replaced with a new one Sept 2017 - 250$

Is the duckbill carbon fiber? Condition?

Duck bill is carbon fiber. Condtion is 8/10 due to a small knick at the top back center edge. Which is why price is low.

Might be interested in a few parts. Will wait until you have the parts off and upload photos.

What size are the tires on the wheels?

285 35 18 front and 295 35 18 rear

Sent from my LG-H931 using Tapatalk

First Dibs on the TB and Injen.

Pmd...send pictures when taken off. Thanks

Your z is by far the Best looking one on this forum.. The setup was perfect..

Off topic.... but free bump! GLWS

Are the side blades the full length ones or the short ones?

Selling the rear diffuser too, by chance?

Why are you selling all this stuff, anyway?

God damnit i just bought new sideblades. how much do you want for rear spats+vortex gens?

Lemme know if you decide to ship items. Highly interested in duckbill, side blades and intakes.

Thanks man i appreciate it.

They are the short ones. and diffuser has already been sold.

Not available.

I will be removing everything this weekend and get shipping quotes. Keep a look out.