How bad is scraping/clearance with the Amuse front bumper?

Depends on your suspension. I am stock and I don't scrape (but I angle every speed bump and steep sidewalk).


Here are some comparative measurements.


Stock height - no body kit


http://www.the370z.com/attachments/e...-kit-stock.jpg


Stock height - Amuse


http://www.the370z.com/attachments/e...ock-height.jpg

Height is not the issue. I am more concerned about scraping the lip since it sticks out further and lower than stick.

I just made an aluminum skid plate for under the lip bottom. Similar to this. But honestly, angle is your friend.


http://i1019.photobucket.com/albums/...ps2d70f457.jpg

Hopefully switching from Springs to Coils soon and getting rid of that wheel gap.

Attachment 130150

Skid plates are a must for these things and they are easy to make.

Bum shot.

Is there any extra hardware or anything needed to swap front and rear bumpers? Also, what are people using to keep stuff out of the front opening?

I do not believe any extra hardware is required.


Mesh is used for the front opening. I got plastic mesh to make it look more like OEM.

I have some z emblems that replace the Nissan hamburgers. Anyway I can get those to fit flush on the amuse bumpers?

Which emblems do you have? EVO-R?

Yeah, evo-r big z emblem with cf backing. Was planning to swap my Nissan hamburgers or put them on 2915 nismo bumpers, but I think id prefer the amuse

They will sit flush. The Amuse bumper does not have any indentations like the stock pumper. Just remove the backing for the tape and stick on (after measuring and aligning everything of course), You can go with CF backing or without. I chose to go without so the OEM paint is seen through the emblem.

It sits fully flush? I was holding them up against my bumper to the side if the Nissan emblem today and it didn't seem.fully flush, plus the tape supplied us pretty thick. Oh well, hopefully it'll work out.

Fully flush.


http://www.japanesesportcars.com/gal...011715-008.jpg




http://www.the370z.com/attachments/e...-kit-image.jpg

http://i3.photobucket.com/albums/y96...psz7h0xjzn.jpg

Cool, looks good

Are those 2 tirangles on the rear bumper to the bottom left and right of the license plate openings or are they solid?

They are open. I installed mesh on mine. Some brands already have the mesh installed

Full add ons

keeping the thread alive:
Photos by me
IG: @my_car_is_my_gf

https://farm8.staticflickr.com/7818/...bc1ea2ff_b.jpg

https://farm8.staticflickr.com/7900/...a2a537f4_b.jpg

https://farm8.staticflickr.com/7863/...a43dcce9_b.jpg

For those who used a custom mesh for the front bumper, what length was the mesh you used? trying to see if the sizing on customcargrills 12x36 inches is enough or if i should get the 12x48 inches.

I went with the 12x48" so I could have extra for the other open areas on the kit. Id definitely suggest it.