I started putting my Swift springs on but encountered a bolt that did not want to come off and I had no penetrating fluid. :mad: impact wrench didn't even work.

had same problem putting on FI exhaust...went to HD, got a Ryobi right angle grinder $29 + cutting blade and made SHORT work of that MF.

:icon14:

Holy crap, how much torque does your impact wrench have?

I'm going to douse it in penetrating fluid and torch the bitch to see if it will break loose.

I also started refinishing my wheels and did this little project this morning in an hour. Don't know what to do with the last slot

http://i207.photobucket.com/albums/b...161853_HDR.jpg

Rear fog light switch for the last slot???

ijdmtoy rear fog light. I could get it but it wouldn't do anything

Bought a new set of Nitto tires NT01 and still waiting for its delivery hopefully by tom. So that I could install it asap.

How do you clean your USB port if it gets dirty ??

Sent from my XT907 using Tapatalk

how dirty you talking?

a keyboard blower if it's dust... maybe a q-tip with some rubbing alcohol then blow it down with the air duster.


edit: or just buy a whole new one =P

vagisil

Sorry didn't see this earlier. It does 250 ft-lbs. I got two cans of liquid wrench and doused every single ******* bolt on the front struts with both cans. Going to attack them again tomorrow.

Made it easy to take apart

ifn u dont want to cut it off, sounds like BACB (big a** cheater bar)

250 ft-lbs is lame if it is half inch drive.My Ingersoll Rand has about 1000ft-lbs in reverse.Which strut bolts are you having difficulty with??