Nissan 370Z Forum - Which Muffler would you get for your 370Z Z34?

Page 2 of 2

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Nissan 370Z General Discussions (http://www.the370z.com/nissan-370z-general-discussions/)

- - Which Muffler would you get for your 370Z Z34? (http://www.the370z.com/nissan-370z-general-discussions/830-muffler-would-you-get-your-370z-z34.html)

Plasmaball

03-04-2009 03:33 AM

Well is it worth it?
Meaning worth replacing?

and thank you

shumby

03-04-2009 03:35 AM

oh yes well worth replacing. I love the extra power I feel in my car along with the deeper louder sound.

Plasmaball

03-04-2009 03:39 AM

i guess i need to go to the websites and see if they have videos of the new exhausts
Stillen did.

LiquidZ

03-04-2009 06:27 AM

I was thinking of Stillen, but I found out their exhaust system is all 409SS, minus the muffler and tips which are 304SS

Zpil0t6

03-06-2009 10:37 AM

spin tech bullets custom with resuage of stock tips.....SWEEEET! WEEEEEEEEE!

cost is about half.....and with test pipes. HP is definitely up...

I cheaped out and did the pop intake.. But i beleive i'm running well over 365 crank.
again i can't say but in encounters with my nephew 335turbo.......hehe. well he is ordering a boost controller and better intake at this point....were i'm still right at 1 grand
1200 really in mods. Breathing only.

arcticreaver

03-06-2009 02:47 PM

Quote:

Originally Posted by kdo2milger (Post 38509)

nope, warranty is still good, however just your catback will not be honored under nissan warranty.

on the upside, most aftermarket catbacks offer lifetime warranty on their parts..

so, you will still be covered one way or the other...

that's good to know. i'll probably start modding the Z after my factory warranty ends. mufflers, intake, and probably exhaust system. by the the warranty runs out, hopefully prices are lower and there are more selections.

All times are GMT -5. The time now is 08:05 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page