Nissan 370Z Forum

Nissan 370Z Forum (http://www.the370z.com/)
-   Nissan 370Z General Discussions (http://www.the370z.com/nissan-370z-general-discussions/)
-   -   Waking up to a puddle of oil under my car = bad. (http://www.the370z.com/nissan-370z-general-discussions/7626-waking-up-puddle-oil-under-my-car-bad.html)

GMZ 08-06-2009 02:52 PM

Quote:

Originally Posted by khtso (Post 140919)
Dealer towed it to dealership. I just looked at it on the lift. You guys were all close. A new crush washer had been put on, but it hadn't been crushed! Drain plug had not been torqued fully (or really at all). I had been a quart low so I think I will be fine. I'm pretty lucky. Well scratch that, the dealer is lucky.

Sounds like they just hand tightened it :shakes head:

6MT 08-06-2009 02:54 PM

Quote:

Originally Posted by NIZMOZ (Post 140943)
You can reuse them. I have for years on Nissans and never had a leak happen.

That's just silly.:ugh2:

bigaudiofanat 08-06-2009 03:03 PM

Quote:

Originally Posted by fuct (Post 140305)
or left the old rubber gasket on when he put on the new oil filter.

Indeed I have seen that to many times:shakes head:

mspeasl 08-06-2009 03:41 PM

Ask for a Tech to do it
 
Quote:

Originally Posted by Zcott (Post 140930)
While it's probably worse at dealerships, this pretty much applies to most service centers. They don't put the certified techs in the oil change area.
That's where the "cheap" labor goes, and you are getting what you pay for. :shakes head:


As the title above states, open your mouth and ask for a tech to change your oil.......... You're the customer not the guy behind the counter writing up the work order. Make sure that it is the same guy each time and the one that does all of the other repairs on your car. In this manner I know what I am getting each and every time I return to the guy that sold me the car.
:tiphat:

TBSS2008 08-06-2009 04:04 PM

I think I am going to start doing my oil changes myself cheaper and I can start using an ester synthetic, but where do you guys dispose the old oil?

Division 08-06-2009 04:46 PM

This is almost as good as mine... I picked up my brand new Z at 10:00PM, drove it for a while, parked it in the garage... Woke up at 6 am the next morning to a nice puddle of Power Steering fluid on the ground.

Same scenario - crush washer, not crushed. (except it wasn't the dealers fault - it was the factories.)

FricFrac 08-06-2009 04:47 PM

Quote:

Originally Posted by 6MT (Post 140763)
It's not "rubber". Nissan uses a brass crush washer on their drain plugs. It is NOT re-usable. They are around $1. So if someone doesn't replace it, they're either stupid or don't know that it can't be re-used.

I just did my first oil change last night. It was very easy. Just remove 16 bolts and 3 fasteners, drop the splash pan and it's so easy that I didn't spill one drop.

They are copper - not brass. Brass is pretty hard and isn't maleable like copper. You can reuse them as long as they aren't totaly mashed but at a $1 a piece why bother. I guess don't sweat it if you have to reuse it...

Mike 08-06-2009 04:51 PM

Quote:

Originally Posted by TBSS2008 (Post 141169)
I think I am going to start doing my oil changes myself cheaper and I can start using an ester synthetic, but where do you guys dispose the old oil?

All auto parts stores and shops that do oil changes are required by law to take your old oil and dispose of it for you for free. I have a 5 gallon gas can that I use to store old oil in to cut down on trips.

spearfish25 08-06-2009 05:29 PM

When I had my first oil change, the 18yo timid nissan service tech actually had the stupidity to say it was the first 370Z he's ever changed the oil on.

I since bought everything to change all the engine and driveline oils myself.

GTRFAN 08-06-2009 05:51 PM

Sorry to hear that mate, at least they took care of it. You should have asked them for free floor mats as compensation. Fark em. ;)

It sounds like the mechanics had a "Bring your kid to work day" and let them loose on your car. Muppets.

I just had my 1000km service, all good so far. They said the oil change was optional which I thought was weird so I had to pay for new oil, filter and washer.

Does the first service in the US include oil at 1000km? (600miles)

I also asked about the oil temp situation as I have been seeing 100C at normal driving. They said the car is designed to run hot and will only be a problem at 140C so not to worry.

Cjanik 08-06-2009 06:32 PM

Quote:

Originally Posted by 6MT (Post 140994)
That's just silly.:ugh2:

I've been doing my own oil changes since I was 18, I have never purchased a crush washer for the oil drain plugs before. Never had any leaks either :) I might start on this car, but then again thats what I said about my 07 R6 and 08 Tacoma, and I still haven't purchased a new crush washer yet.

cptspeed 08-06-2009 06:36 PM

x2

kannibul 08-06-2009 07:32 PM

Quote:

Originally Posted by TBSS2008 (Post 141169)
I think I am going to start doing my oil changes myself cheaper and I can start using an ester synthetic, but where do you guys dispose the old oil?

Autozone, O'Reilly's

Most of the places that sell car parts take oil and send it off for recycling.

The fire station in my little hick town where I grew up, would let you dump oil in this huge canister behind the building for recycling.

kannibul 08-06-2009 07:33 PM

Quote:

Originally Posted by FricFrac (Post 141262)
They are copper - not brass. Brass is pretty hard and isn't maleable like copper. You can reuse them as long as they aren't totaly mashed but at a $1 a piece why bother. I guess don't sweat it if you have to reuse it...

Most crush washers are aluminum.

kannibul 08-06-2009 07:34 PM

Quote:

Originally Posted by Mike (Post 141265)
All auto parts stores and shops that do oil changes are required by law to take your old oil and dispose of it for you for free. I have a 5 gallon gas can that I use to store old oil in to cut down on trips.

5 gallon bucket and lid is what I use. I'd use a jerry can if I could find one for cheap!


All times are GMT -5. The time now is 01:41 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2