:roflpuke2: pulling hard aside, i got all the basics except which wire goes where? esp. that srs indicator looper / airbag sensor.

for the SRS you should have 2 resistors for them to trick the srs that there is some load.

i believe these airbags are dual stage like the previuos Z and G.

This is which I have no clue how it will insert on the sensors. It looks easy but last thing I want to happen is the srs indicator turned on and wont come off.

it's easy. you just push the resistor pins into the harness female terminals, bend the resistor and tape it to the harness with e-tape. if you're anal you should also put a fuse in series but not necessary. repeat for the other harness.

Anyone got a pic on how the resistors connect? :icon17:

Did you get this installed yet?