Nissan 370Z Forum

Nissan 370Z Forum (http://www.the370z.com/)
-   Nissan 370Z General Discussions (http://www.the370z.com/nissan-370z-general-discussions/)
-   -   Manual Transmission Engage Height (http://www.the370z.com/nissan-370z-general-discussions/24183-manual-transmission-engage-height.html)

g96818 08-29-2010 11:19 PM

Quote:

Originally Posted by Soygen (Post 699117)
In for the pic. I'm definitely interested.

I just threw a bunch of big washers onto a bolt and dropped it into the groove on the plate. that way no drilling was required. plus it's freaking hard to get a wrench back there to put the lock nut onto the table shoe that was in the other link and washers make adjusting the height easier. and yes i used tape to keep the 2 sections seperated when sliding it into the groove.
http://www.the370z.com/members/g9681...0-dsc01688.jpg

Take out that rubber bumper and replace with a bolt, nut, and a bunch of washers. This is for the clutch safety. make sure you don't put excess pressure on it.
http://www.the370z.com/members/g9681...9-dsc01687.jpg

Quote:

Originally Posted by Jeffblue (Post 699221)
woudn't putting washers behind the pedal just prevent you from depressing the clutch all the way?

why do you want to? all you need to do is depress enough for the clutch to disengage and you're all set.


All times are GMT -5. The time now is 07:45 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2