Disabling VDC
 

Hi guys,

I'm new to this forum and I have some doubts in disabling the VDC

Is the M143 the correct wire to cut in order to disable the VDC?

GROUND DISTRIBUTION
http://i305.photobucket.com/albums/n...pslt2kzrfu.jpg

HARNESS LAYOUT
http://i305.photobucket.com/albums/n...psbdw4qlo9.jpg


Thanks,


Kam

There is a thread on here on which wire to put a switch on. I would not think you would want to leave it off all of the time.

Could you please share the link to the thread you have mentioned? I have tried to search VDC but nothing came up. Thanks!

I did plan to install a switch in it but I need to be sure of which wire to cut so I can solder it in.

Search for yaw sensor.

If the site's search isn't finding what you want, use any major web search engine and add "site:the370z.com" to your search string. Eg, yaw site:the370z.com

I have found the thread you have mentioned but my bad for not asking my question specifically.

My car is a 2017 370z Nismo and the wire color may not be the same as previous models. That's why I was trying to confirm if the M143 wire is correct one to cut and letting me know the color code would be nice too.

I thought I should try to give it a shot in this forum to see if anyone can help.

I thought at least EcuTek could do something about VDC/TC without cutting anything. Both are ways to ruin your warranty, but technically you can always flash back to stock vs. having to mess with hardware.

Look here

http://www.the370z.com/diy-section-d...er-switch.html

Simply check the wire colours .........

FWIW, the thread above worked fine for a 2016. Hardest part was selecting a proper sized switch.