Update: Steering Lock issue - Bypass Kit!
Hi all,
2010 owner here that recently encountered the steering lock failure and resolved it. I've known about the problem for a while but never paid much mind to it since I naively thought it wouldn't happen to me. Well, it did, at ~51k miles. I was stranded on a Sunday night in the city and was nerve-rackingly trying to DIY fix it via the resources on this forum to no avail. No amount of hammering to that steering lock was going to get it to work. I had to get it towed home. I found out about the Voluntary Bulletin but they declined me because I have a revision C, and the Bulletin only covered revisions A and B. The next thing was to chance it by buying a used steering lock on ebay. They're going for $150-200. However, I came upon this one seller that had sold over 700 of these so called Bypass Kits for $103. It appeared to be an official Nissan part but I found it odd that there was almost nothing about it when searching via its serial number, including this forum. I took a chance and bought it. Had it installed by a friend and voila, it worked! With this bypass kit, you don't need to cut any wires or pull any fuses after. It's a direct plug and play replacement to the steering lock except there's no more steering lock. No need for reprogramming by the dealer (this is a lie by them to get you to cough up another $200-300). As advised by others already, don't wait until your steering lock fails on you and leaves you stranded. They made up to a revision D or E, which all will fail over time. If you have a 2012 or newer model, they eliminated the steering lock on them so you don't have to worry about this issue. If you have decided to ignore all warnings and ended up here reading this thread wondering how to get your as$ unstranded. Take a hammer and bang away at the steering lock located under the steering column while pressing the start button. You'll know it worked if you hear the steering unlock disengage. If that didn't work then you'll just have to pay for a tow like i did. Now onto the actual fixing, I don't recommend spending the money on another steering lock module that will eventually fail. Just pay the $100 for this bypass kit and be done with it. It says Altima in the title, however the cars that have been effected and are compatible with this kit are Altima, Maxima, 370z, and GTR. Part no. 48708-9N00A Link to ebay item: 09-10 ALTIMA MAXIMA STEERING LOCK BYPASS KIT FOR 48700-9N00B NO PROGRAM NEEDED | eBay Would appreciate a rep if this was helpful. Thanks all |
just FYI, this part is only $85 from Nissan, and courtesy parts has it for <$60.
Box Kit-Steering | Genuine Nissan | 48708-9N00A : CourtesyParts | Genuine OEM Nissan Parts & Accessories Also, pulling the fuse is free =) |
Procrastination is expensive. Lucky me I was able to mash the slu and got it unlocked when it failed. Pulled the fuse and no more issues since.
|
What does this bypass do? I've looked at the pictures and can't figure out how it's supposed to work.
|
Quote:
|
Good looks on finding it for so much cheaper at ~$60. Much better price than what I got it for.
To clarify, this is the cheapest and easiest option if: 1. you didn't pull the fuse already while your steering lock was working 2. your VIN isn't covered under the Voluntary Bulletin 3. smashing the failed steering lock doesn't work It installs exactly where the steering lock should go with 2 hex bolts and uses the same wire plug. |
Quote:
|
Quote:
|
Not working
Bought that part and it did not work it was a waste of time and money...and i do have the red key flashing it wont start...I am not trying to spend so much on a brand new steering column
|
Quote:
Sent from my SM-G965U using Tapatalk |
Mid year 2011’s dont have the steering lock either
|
Quote:
|
Quote:
|
just pull out the fuse and you're good to go
|
Just had my steering lock fail (rev D, was previously replaced from the TSB in 2013).
Mine failed in the "unlocked" state (I could still turn the steering wheel), which I'm not sure is normal? and I could not get the car to turn on or ACC at all. The start button showed "LOCK" and the yellow key light came on solid, but the key fobs were working fine. This youtube video saved my day: https://youtu.be/pLPTNm0xxy4?t=70 Just short the pink wire to ground to bypass the broken lock and get the car to power on. Removing the fuse while in ACC did not fix anything, and it still goes into lockdown without me keeping the pink wire permanently grounded. I ordered the 48700-9N00B delete kit and will see if that works when it ships. |
Quote:
|
BTW, the most likely reason for your situation is the locking pin did not retract completely. It probably retracted just enough to allow the wheel to turn but not enough to trigger the electrical signal to allow power to the vehicle. Hence, the steering lock is in what appears to be an "unlocked" position but you still cannot start the vehicle.
|
Quote:
|
Quote:
|
is rev D the latest?
does grounding the pink wire let you unlock it and start the engine? do you have to keep it grounded to drive the car? Thanks. Quote:
|
Rev D is the latest revision for US models. It is still prone to failure. My Z had a Rev D from the factory and was not covered by the recall. Having read about numerous Rev D models that still failed, I pulled the fuse immediately :twocents:
Grounding the pink wire electrically bypasses the ESCL (steering lock), allowing you to start the car. Once the car is started you're good. You do not need to keep the wire grounded. |
would it be better or easier to just ground the pink wire instead of pulling the steering lock fuse?
I assume that you have to ground the pink wire when the steering lock is unlocked? Quote:
|
Well, you can either ground the pink wire every time you want to start the car or you can pull the fuse once. Your call.
Grounding the pink wire would not retract the pin inside the lock, so yes, I imagine that the pin needs to be at least partially retracted enough to allow the wheel to turn. You're not going to get very far with a locked steering wheel even if you can get the engine to turn on. |
thanks for the clarification.
Quote:
|
Quote:
|
Teardown of my steering lock in case anyone is interested: https://photos.app.goo.gl/MKtf8JiypjYb7PTV9
|
Sooooooooo glad I found this thread before buying a new ESL.
Even though Coulter Nissan sells the ESL for $315, $77 for the 48708-9N00A is a helluva lot easier to swallow. Big ups to WDKWang:tup: |
Quote:
Repped! |
Does pulling the fuse throw any kind of warning lights on the dash like the key icon or anything?
|
Quote:
|
Quote:
|
All times are GMT -5. The time now is 08:04 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2