turtle64b

Sorry to hear about your car, I was interested in the hood. Whenever you get a chance please message me back about a price if it is available.

Just curious bro, how much power and tq are ya making?

Yeah man no doubt, I work weekends only so I'm available all week just let me know when u need some help or just moral support lol I know how it can be! I'm in goose Creek

yo we need to link up man let me see that build. i need other higher hp VQs to ride with, just finishing up my boosted performance build g37 follow me on the gram @mercerrr_

Do you have a wideband meter? My car would do that sometimes on the original revision of my tune. AFRs would drop to the bottom of the meter and the engine would sputter because it was getting...

Do you have a wideband meter? My car would do that sometimes on the original revision of my tune. AFRs would drop to the bottom of the meter and the engine would sputter because it was getting...

Smoetimes I think about taking a highway exit to take the "scenic route" in the mornings haha.:driving:

Make sure that you've got the right cables plugged in to the right spots. the cables and connectors are identical for the MAF and the throttle body with the exception that one has 6 wires and the...

You can get at either tensioner from above. Either use a 3/8 drive breaker bar (need at least 2' for enough force to move tensioner) for the serpentine tensioner or use a 9/16 (I believe) crowfoot...

I would post my videos of my trip to the drag strip Saturday if it was anything more than tires squealing and BOV air haha. But really. Bigger. Better. Tires. Suspension mods help too haha

Looks pretty good! My first suggestion is to search around for secondhand parts. Things like oil coolers and such that have no moving parts don't lose a lot of functionality over time, so get'em...

It's not complicated, just difficult to get the hoses routed through all the right places as far as the system installation goes. The fuel system mods took about half of my install time. The...

Where are you guys sourcing your pulleys? The 9lb pulley on Z1's website is ~$155, ConceptZ ~$220, I couldn't find a 7-rib pulley on Vortech... I saw some discussion about picking up a smaller...

Where are you guys sourcing your pulleys? The 9lb pulley on Z1's website is ~$155, ConceptZ ~$220, I couldn't find a 7-rib pulley on Vortech... I saw some discussion about picking up a smaller...

Here are my before and after(ish) dyno sheets. I say after-ish because after sending my stuff to Sebastian, he noticed that I flashed tune rev 2 instead of rev 4, so I'm a moron who can't tell the...

I sent the data from my 2 dyno runs to Sebastian, so I anticipate good things! Woo from the forum here lives out by me and said he was running ~447 on a similar setup without fuel mods (other...

Make sure that you are not over the side on any of the pulleys and that you have it routed the correct way. I have the same pulley setup and the green belt that TBatt sent with it fit like a glove....

Slippage will still occur with the stock 8lb pulley. "Coincidentally" it seems to happen around the time the SC peaks out at 8psi. With the TBatt extra idler that eliminates the slip, I believe folks...

This is exactly what I am doing. I didn't see anything about transmission stuff on the FI website other than the flexplate. I know that Level Ten advertises a tranny built to 700+ hp for close to 5k....