Well I went to Z1 Motorsports here in Ga and had them re tune my car from scratch it took John 4hrs. total to finish it up but before he started I had a 10lb pulley and it only made 445rwhp then I took it off and put on a 11 lb pulley on made 449 first pull(this was a few weeks ago)John at that time only got it to 451rwhp so he told me to come back when he has more time to spend with it well 4hrs seem to be enough time b/c here is what he got.

http://www.the370z.com/members/baer3...dyno-sheet.jpg

Nice!

I just picked up a Snow Performance water/meth injection kit,this kit is very easy to install but trying to figure out where everything is going is quite a challenge,I'm about finished with it will post pics later as I get closer to being finished.:tup:

Pics later:icon23:

I have to go buy a tap for the intake tubes:ugh2:

What methonal injector sizes have you selected?

Whatever fits in his butt. Them hemorrhoids can get hot. :bowrofl:

175ml @60psi pump pressure but the tech at snow said my kit comes with a 220psi pump so these should flow about 200-225ml he said that's a good place to start from.

1 in each intake pipe 1-1.5 in after MAF

I wonder what they would say about meth kit on a NA car. I don't see how it would hurt

Did a quick search. Many variables when NA come onto play. Better for high compression motors where timing comes into play.

I have a Aquamist system and will be installing a 0.4 pre-MAF and 0.7 after MAF in the intake pipes. Somewhat like GTM's system or at least having the same intent as GTM's. I won't be injecting methanol into the air cooler.

It will be interesting to see how our stage 1.5's compare after I'm done.

Here are some pics of whats going on with the install.

http://www.the370z.com/members/baer3...e-s-p-pump.jpg
http://www.the370z.com/members/baer3...under-foam.jpg
http://www.the370z.com/members/baer3...rictronics.jpg
http://www.the370z.com/members/baer3...es-holders.jpg
http://www.the370z.com/members/baer3...ook-bigger.jpg
http://www.the370z.com/members/baer3...-undecided.jpg
http://www.the370z.com/members/baer3...-injecting.jpg

Love the PW you have done an awesome job with your Z buddy. Great numbers too btw :tup: are you running test pipes?

Thanks :tiphat: no I have Stock cats.:tup:

Can't wait for you to test that baby out.