this is good news, fingers crossed for restoration and a full recovery.

Good morning folks!:tiphat:Gotta work till noon,then go home and get the Z out for some drive time!:happydance::driving:

[QUOTE=-ZS-Carpenter;3950605]Busy day today.

New lower oil pan going on Melissas car. The one on it has a nasty looking rust spot that looks like could turn into a second drain at any time:shakes head: Old one gets to be powder coat test dummy now :tup:

Don’t know what it is about Nissan oil pans but all 3 of my maxima’s oil pans have rusted badly :shakes head: my current 06 is in poor condition.
I’m going to try and stretch out another 2yrs. ( winters ) out of it before it goes to the junk yard :rofl2: I’ve been keeping the rust under control on the RR quarter panel but the floorboard on the passenger side is in pitiful shape :icon14:

To test if it's cured use a q tip with some acetone in a spot you can't see. If it's not clean put it back in the oven

Sent from my SM-G965U using Tapatalk

Happy Saturday!! :happydance:

Off to some disc :tup:

Why do I have the feeling that the word 'ACETONE' in some form or fashion will end up in a few of Zoren's comments here this weekend? :ugh2:

100? Wth?? Fire up those fans!!!

Partly cloudy with a high of 87 here today. Not bad. :tup:

You got that right! Its perfect atm, 73.

:tup:

I'm thinking Q-tip. :icon14:

Maintenance day on the Z.

Change the rear tires. Going to put on the Mich Cups that JC gave. :tup:

Oil change. Got close to 5,000 miles on it since last change.

Got a new back-up switch for the tranny.

Going the change the cabin filter for the first time. :eek:

Have to adjust the clutch pedal switch. My cruise control works sometimes. If I use my foot and pull up on the clutch pedal. Sometimes I get the cruise to work. :icon14:

It's beautifully outside. Hardly a cloud out. 75F going up to 90F. But the humidly is a killer. Foggy as chit this morning.

Laptop is done :tup: only took 4 hours longer than it should have :icon14:

The versa is fighting back also :ugh2: One of the bolts was rusted away :shakes head: Melissa was right next to napa luckily so a screw extractor is en route :tup: Have to source some new bolts after I get that one out and clean up the bucket of silicone the old pan was glued on with :icon14:

Speaking of napa. You tool freaks should pick up a set of theses adjustable pry bars :tup:


https://uploads.tapatalk-cdn.com/202...10e8efc1f2.jpghttps://uploads.tapatalk-cdn.com/202...5f82f6c1de.jpg

Sent from my SM-G965U using Tapatalk

I have a set of them.Gearwrench brand.They are badass!:tup: