Have a wonderful Tuesday, everyone :hello:

Good morning guys!

Hey Ms. Pint! :hello:

My co-worker does a lot of side work there, I'll have him look around the employee store. :tup: :tiphat:

:hello: Morning.

dude. whats a rep?--eastwest

reps out itches...

enjoy your reps...

:hello: mr. onzedge

enjoy your rep.

I hear that.

Did you put that cover panel back on between the bumper cover and rad cradle?

The Herman killer chairs are sweet. I always wanted a Setu :tup:

chase, i gave you a rep this morning

use it wisely

Not my party, I just show up and eat.

bumper cover and rad cradle?

:rofl2::rofl2::rofl2::rofl2:

beg them to move it one week later mr. madwi.... :icon17:

Sweet body kit :icon17:

This piece. It raises the bumper cover enough to fill those gaps.

There are adjustments that can be made in the support bars but I wouldn't go there if you don't have to.

I never touched that section. Just the 7 clips in front of it holding the actual bumper in place. Does that panel help align the hood/headlight to be tighter together?

:iagree:

Not directly. The panel slides underneath the bumper cover which raises it up and fills the gap. From the pics you posted it looked by a similar amount, though if that panel is in place then that's not the issue.

Under that panel there are three metal brackets that protrude forward underneath the bumper cover to support it. *note I would try taking the bumper cover off and reinstalling once before adjusting these* if you bend the outer two up just slightly you can raise the cover and make the gaps as small as you'd like. After doing the other two if the gap is t the same in the middle with the hood closed and latched then raise the middle one up just slightly too. Little movements will raise it up more than you'd think so don't go crazy on it.

It doesn't take much for these brackets to get bent out of place. Resting your hand on it with even a little weight is enough. Especially when you've been messing around with the cover.

It sounds like that is for the front of the hood though. My issue is a gap between the side of the headlight and side of the hood. The hood itself is flush with all the panels. Unless I am just not understanding you which could very likely be the case hahahaha

The gap can almost fit a finger inside.
http://i1097.photobucket.com/albums/...pszdh3vgf3.jpg

:gtfo2::gtfo2::gtfo2::gtfo2:

those fricken gaps suck... i got a pretty nasty one too... but i can deal with it, the hood is sexy:yum::yum::yum::yum:

Just about as many nismo stickers as you stuck on your ride. :icon17: :icon23:

Get rid of those shitty hood struts and it will fit perfect, like it did on my z.
:p :driving:

Does he have the SMO sticker, too?

Which ones are the shitty ones?

:inoutroflpuke::inoutroflpuke::inoutroflpuke:

no way jose....:icon23::icon23::icon23::icon23:

none, I am just giving him **** because Seibon says not to use hood struts with the hood.

:icon18:

Any idea what caused yours? It's really annoying me since that's all I see now hahaha

hood struts. :icon17: It needs to be tweaked to sit straight is all. I slightly loosen the nuts holding the hood on and then grab both sides of the hood and get it to line up correctly. I dont dare do that with the hood struts, I might break something or tweak those out of alignment.