Yep

Have you tried hitting the flame sensor lightly with a piece of fine sandpaper? Or a Scotch-Brite pad?

Kenchan working on the furnace...
http://www2.b3ta.com/host/creative/6...beakerburn.gif

yah, been getting a single blinking LED.. thing is an old pos from da late 90's so who knowz..

we had a power outage earlier in da week where the temp inside da house went down at least 6F. from dere the furnace has been struggling to get back up to da temp i had it set at since its been pretty cold again outside.

it seems it over heats and shuts down before it can finish getting the hauz up to temp. the flame sensor was kinda dirty though.. its now within 2 degrees of the temp i had it at. hopefully i can get da thing to stay.

:iagree:

yah, i used a fresh dollar bill. it's clean now.

That was the problem we had and it's been working ever since.

yah, hope dis cures it. if it dont i think i need to get the duct work cleaned and probably get a new IFC.. this is the 2nd IFC in da thing so im pretty sure its about due for a new one. da humidifier solenoid trigger dont work no more anyway...

Mrs. BoneZ yelled "who the hell has been in the driveway at the old house?"

I plead the fifth.

https://uploads.tapatalk-cdn.com/201...0808184b71.jpg

msbc? :confused:


hey u got a new spoiler :D

Reservoir and radiator showed up. :tup: Radiator was well packed and all the fins are straight :excited: Ordered the acrylic lines and silicone cord for bending the tubes.

alright da hauz is within da swing temp.. +/-1F. :D hope da thing is fixed...


which reminds me.. were is da amazon delivery van? :excited:

I need to decide what waterblock to use for cpu, 1150 chipset board. Hmmm, decisions.

nice.. i know its for ur pc, but most folks probably cant tell if u talking pc or for ur car :rofl2:

for my Dyson!! :mad:





:ugh: :rofl2: