Installed the GRIP type 2 exhaust on my Z tonight, exhaust looks great, sounds great.

One problem the exhaust seems to be hitting the cross member on the passenger side, just like the guy in the previous pages. I was worried about the gap between the x-pipe and the cross member when I put it together, but it didn't come to close, after about a 40 minute drive, it rubs under decel and idiling.

I suppose I need to get back underneath and try to use a jack raise the x pipe.

I will let you guys know how it goes.

Joe

You have to raise the midpipe and then bolt it up. It will hold just fine. When adjusting, you can push it all the way to the top so that there is room for play when you tighten it.

Alex

Post vids guys!

installed mine this past weeked, posted a review. Car sounds amazing ! everythings great, cept the whole crossmember deal. going to adjust it this weekend. Besides that, awesome exhaust :tup:

Pre SEMA SALE FOR THESE BAD BOYS

:tup::tup:

Hit us up for sale info! We still have a few in stock :)

Good in stock

Do we order directly from you?

Through our authorized vendors on this site.
Driveline Motoring
Corner3garage
VividRacing

If you have any technical questions please do not hesitate to ask. We check our PM's hourly

We have a few left in stock, at the promotional rate :). Let us know if you need any pricing.

Hey Alex, when will the type 1 release?

Hmm I don't see my name on that list

My bad. i went down through the vendor area and didn't see Amplified.

Amplified Motorsports = ARK Authorized vendor

The Type 1 has been released :).