Greddy Evap Bracket Dimension
 

Hey All

I purchased a TI-C exhaust from a fellow member who sold his car and when I recieved the exhaust, the bracket that holds the Evap unit is missing. I would like to fab the unit but need the exact dimension for the following per picture below:

A) Total Length - 22 1/4"
B) Width - 6 7/8"
C) On center bolt hole from edge hole to center hole 10 1/8"
D) width of small bracket 2"
E) On center between mounting bolt - 5 3/4"

http://img823.imageshack.us/img823/3162/bracketshc.jpg

Any help is appreciated

Major thanks in advance... Ended up making this

http://www.the370z.com/members/zakim...vap-bracke.jpg

If you can't get the dimensions, I would try and get in touch with Greddy / Trust. They're located in California and could get you the part.

Thanks Staples...That would be my next bet but being in Ottawa, it would take a while to get it in and I really want to install the exhaust this weekend. I am decent with a welder so I figure I make one.

scottnismo is who I sold my exhaust to, good luck. He should be able to get those.

thanks lude .. I've just PMed him

Oh, well in that case, good luck! :tiphat:

I ended up making this. The center bracket was made that way because I didn't know the exact location of the bolt holding the EVAP unit. It was fab when the car was being wet sanded by the dealer.


http://www.the370z.com/members/zakim...vap-bracke.jpg