stillen supercharger belt tensioner
 

Hi guys im trying to remove the tension from the small belt on the rear of the charger to take the belt off but seem to be getting nowhere
im winding the adjuster and nothings happening am i missing somthing ?
tia

Loosen the nut in the puller first

The 2 Allen heads or the one that runs threw the idler pully

Sent from my SM-G920F using Tapatalk

Technically, either. But I'm talking about the one bolt through the idler

Yeah I did that
Maybey I need to loosen the Allen heads out

I need to get the belts off to see if the noise I'm getting is pre charger or if I need to send it away to vortech for repair

https://youtu.be/e7vZJ_1Zvk8

Sent from my SM-G920F using Tapatalk

Yo dudes, just wanted to see if there was anyone out there that's had personal experience with replacing the small supercharger belt. I was driving to work yesterday when it abruptly broke. Turns out it was all cracked, likely from the colder weather etc. Ordered a new belt from Stillen but they weren't the best help giving advice on how to deal with this..

I understand that you have to release tension from the lower idler pulley via the bolt that faces downward. Only there appears to be no way to access it aside from underneath and likely having to remove other stuff. For instance there's a hose and electrical line right next to it that have next to no slack. It also looks like getting a socket might not work because there's a piece of a metal tab or something right under it as well..

I'd have an easier time describing this if I could see a damn thing down there it's so crowded and at the worst angle to get light on it. It's like the person who designed it was super into riddles or some ****. Why the f---k can't it be set up in such a manner where it can be easily accessed from above??

Anyways, any advice would be greatly appreciated!

You can get it from above
It's a knuckle cutter bit possible

Sent from my SM-G920F using Tapatalk

yes, you can get it from above.

Are you guys using a socket wrench?? Again, not sure if I could even get one on there with that metal tab in the way. I might be able to get a box wrench on it but there's no room to actually twist it or even get a decent grip on a handle. Did you guys remove any hoses etc?

I used a open ended spanner and lots of little turns lol

Sent from my SM-G920F using Tapatalk

ugh.. I think I'm going to get one of those open end spanners with the ratchet function built in because that bolt location is total bs

Part of me wants to rip the whole thing out and reengineer it to make it possible to spin it without wanting to slit my wrists just looking at it..

I mean, if that whole mechanism was angled like 10 more degrees no one would have to sit here listening to me b-tch about it..

I replaced my SC belt a couple weeks ago. I used a crow's foot socket and a 3/8" extension to get it down there from the top. As mentioned, make sure you loosen the pulley bolt before loosening the tensioner. It's probably easiest to cut the old belt off. Then remove the idler pulley, and loosen the tensioner bolt by hand. it moves a lot faster that way. Then get the new belt on the pulleys, and fit the idler back on. Then start tightening the tensioner 1/3 turn at a time. Once the idler is back on and the tension is pretty good, tighten up the pulley and double check the tension and you're done! It's a mega pain in the ***, but doable. Good luck!

Thanks man, a co worker mentioned using a crow's foot socket as well. I ended up getting at it from underneath with a long socket wrench extension which was WAY easier for me than screwing around from up top..