that was one on a silver car and one on a dark blue. i did the install and was very careful about maximizing the adhesive strength so no, i did not have build up on the seams.
after waxing i took my soft MF towel (and with some QD) gently ran it across the seam and remove the wax/polish. it was very clean when i sold the cars. |
cool
Did you use a heat gun or blow dryer with your install? Was it pretty easy to install? I have seen videos and it looks pretty simple. I think the hardest part would be keeping trash out from underneath the film. Any tips for me?
|
no heat gun for me, but when i did the headlamp clearbra i used
a heat lamp to make the material very soft. after install i let it bake under the heatlamp for a good 4-5hrs since it was cold/wet outside. :) install is cake, you need to be very patient. also there is some pulling involved (stretching over bumpers) so that's where things might feel kinda foreign to you if you've never done one before. otherwise my tip of the day is to keep your fingers wet while handling the adhesive side. :p otherwise you will end up with finger prints. |
great!
Ok, thanks for your help!
|
?
Does anybody else have some measurements to compare?
|
All times are GMT -5. The time now is 05:58 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2