Nissan 370Z Forum - how to drill/screw into carbon fiber pieces?

Page 2 of 2

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Exterior & Interior (http://www.the370z.com/exterior-interior/)

- - how to drill/screw into carbon fiber pieces? (http://www.the370z.com/exterior-interior/84674-how-drill-screw-into-carbon-fiber-pieces.html)

XwChriswX

01-14-2014 04:19 PM

Quote:

Originally Posted by NissanFan (Post 2651223)

if the screw tip on the tapping screw has a bit you can, but if not, best you drill a hole the diameter of the shaft of your tapping screw.

dealers like using those tapping screws that has a bit on the tip.

looks like this. these you dont need to make holes.
http://www.tsjbuilderproviders.com/i...ling-screw.jpg

:rofl2: damn, so strict. :icon17:

http://www.thehealthygamer.com/wp-co...tip-10e54b.jpg

:icon08:

dudesky

01-14-2014 04:26 PM

Ah Hah, so as long as screws have some sort of sharpness on the tips, I do not need to make pre-hole :) thank you NissanFan for the detail description and a picture of tapping screws :)
more likely I'll be using this type of screws http://www.landwide.com.tw/Templates...Head-001-1.jpgthat have very pointy tips

NissanFan

01-14-2014 09:05 PM

Quote:

Originally Posted by XwChriswX (Post 2651381)

:icon08:

:icon08:

:icon17:

All times are GMT -5. The time now is 01:34 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page