Nissan 370Z Forum
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)
-   Exterior & Interior (http://www.the370z.com/exterior-interior/)
-   -   Skid plates on your front lip or bumper (http://www.the370z.com/exterior-interior/69499-skid-plates-your-front-lip-bumper.html)

dP3NGU1N 04-14-2013 10:49 PM
Quote:
Originally Posted by Waizzz (Post 2266665)
I have a few questions :)

1) Where did you get the metal?

2) What did you use to cut it to the shape you needed?

3) How are the attached to the car?
Can't comment on 2 and 3 but there are specialty metal supply stores in LA and OC.

Industrial metal supply in Burbank comes to mind. They also have a shop in Irvine if that's closer to you.

zilverbullet 03-21-2014 04:03 PM
Thread necro - Going to be tackling this soon.

Axmea, could you take some shots of how the #10 screws are holding up? Trying to figure out whether I want to use screws or countershrunk rivets.

Thanks!

martin82 03-21-2014 04:10 PM
Flymotorsports has one for amuse bumper http://img.tapatalk.com/d/14/03/22/y8ypuzuv.jpg

zilverbullet 03-21-2014 04:43 PM
That looks good but I'm looking to apply to my varis front lip similar to the OP

axmea? 03-22-2014 02:52 AM
Quote:
Originally Posted by zilverbullet (Post 2747535)
Axmea, could you take some shots of how the #10 screws are holding up? Trying to figure out whether I want to use screws or countershrunk rivets.

Thanks!
The screws are holding up really well. I'd make it with less screws the next time around.

DEpointfive0 03-22-2014 02:55 AM
I made one for my Stillen front out of... I don't know what it's actually called, but some plastic, it's REALLY strong, but slippery at the same time

OMGWTFBBQ 03-22-2014 11:54 AM
What'd you use to cut/shape the plastic?

DEpointfive0 03-22-2014 11:59 AM
Quote:
Originally Posted by OMGWTFBBQ (Post 2748616)
What'd you use to cut/shape the plastic?
Band saw. I made it 3 piece so I can replace the parts that wear first


All times are GMT -5. The time now is 06:00 AM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2