Originally Posted by PR370z (Post 822752)

Finally the power window switch for the passeger door was replaced, and everything is working fine. There is a circuit board with some chips on the switch assy that control the auto functions of the power windows. So if ALL programming attempts fail (like in my case) you probably have a bad switch.:ugh2:

Originally Posted by TreeSemdyZee (Post 814419)

Actually, you're supposed to hold the button in the down position for a few seconds (you'll hear a click). Then close the window and hold in the up position. Only go to the first click. Don't go to the auto position on the switch. If this doesn't work, try a full reset. Hold the button in the down position for twenty seconds, then close the window and hold for another twenty. The most important is to not put the button to the auto position.
I did it a gazillion times this summer the resets always worked.

Originally Posted by kenchan (Post 1053200)

Yah whenever the switch control on the door is unplugged from its harness you need to do this.

Originally Posted by Amazingz03 (Post 1057249)

I had the same problem today after i got my car back from the collision shop.. My driver side window wouldnt go up after i closed the door. I did the 5 sec reset and it worked like a charm. I love forums. 99.99999% of the time its better to do research here then go to a f-in dealership.

Originally Posted by spearfish25 (Post 814078)

You say you tried everything. I assume you've done this:

Have the car turned off.
Press the ignition twice to get into ON mode, but don't depress the clutch (Don't start the car)
Using the window switch, fully lower each window and then fully raise it back up.
Push ignition once to turn off the ignition.
Start car normally, windows should be reprogrammed.