I just sent EVOR a PM asking for the 1 piece cf lip!!! :happydance:

Here is mine but I got from a different vendor and cheaper:

http://i92.photobucket.com/albums/l2...a/370Z/040.jpg

http://i92.photobucket.com/albums/l2...a/370Z/041.jpg

What different vendor? It's an evo-r product unless you got it from the Z store

Some nightime pics:

http://www.the370z.com/attachment.ph...1&d=1288660452

http://www.the370z.com/attachment.ph...1&d=1288660452

Wrote this up for somebody and thought it might be helpful to others:

Installing is easy but just take your time. As with any aftermarket body parts install, test fit everything first.

-Clean the all the piece and apply double sided tape.

-Clean the bumper with some Bug & Tar remover and make sure there is no residue left over.

-Install one of the side pieces first, not the center. It should line up pretty well with the bumper's lines. Attach with just the double sided tape.

-The center piece is next. This is a key step. Peel off just enough tape
backing so you can peel it off with the center piece set flush to the bumper later on. You want to be able to adjust the center piece from side to side, so don't fully apply it to the bumper just yet.

-Have a friend hold the center piece in place while you put the other side piece on (again with just double sided tape). The side pieces will hold the center piece in place.

-Center the "center piece" so the gaps on either side are equal and peel off the rest of the tape backing.

-Step back and admire for a minute :) Not done yet.

-You will need to jack-up the car to put the screws in. The factory jack works fine if you do one side at a time.

-Using a 1/16" drill bit or any drill bit slightly smaller than the provided screws, carefully drill out some pilot holes into the bumper using the holes already on the lip as a guide.

-The provided screws are self tapping. Using a hand screw driver only (no power tools!) tighten until flush.

-All done, enjoy!

i use rubbing alcohol to remove any wax before i apply any adhesives.

also heat it very well... like ambient temps over 75F and let it cure at least 24hrs.
best if you can get the mounting surface very warm (almost hot) to the touch using the sun or IR heater/heat gun.

no water, no rain, etc. keep it dry for 24hrs.

Why dont people remove the stock bottom sport lip thing< I feel like it looks odd with this lip, and I bet it would flow better if that piece wasnt their.

anyone not have to paint the black side pieces. are they holding up okay?

I didnt paint mine, cross your fingers lol. It's only been a few days of driving though.

Yeah... after seeing my pictures, I started to wonder how it would look without the sport lip.

thezstore left out my screws. what kinda screws do i need to go get and how many. Someone please chime in

trying to buy this... dont see it on thezstores website... and cant get ahold of evo-r (website down and no PM replys)

i could order it on ebay i guess but it costs more there... the first post of this thread shows it as a bit less expensive. ideas?

The Z store has it under new items.

Linked here: The Z Store! Nissan-Datsun 240Z-260Z-280Z-280ZX-300ZX(Z31/Z32)-350Z-370Z Parts: Latest 370Z Products

Sorry guys, my Domain has expired. Trying to get it back. I'm in Mexico now...