Nissan 370Z Forum - Cut hole in interior so I can adjust rear coilovers

Page 2 of 2

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Exterior & Interior (http://www.the370z.com/exterior-interior/)

- - Cut hole in interior so I can adjust rear coilovers (http://www.the370z.com/exterior-interior/103600-cut-hole-interior-so-i-can-adjust-rear-coilovers.html)

redondoaveb

02-19-2025 12:15 PM

Quote:

Originally Posted by nasm (Post 4054301)

Many thanks, do you have any idea about the diameter of the bigger circle, others two they did. Because the cut you did in your car is smaller.

Once again, thanks a lot.
regards,
N

I dont know the size of the hole that he did. I'd look on Amazon and find some where around a 2 to 2-1/2" cap and do the hole the same size. I wanted mine small. I was able to just install a small rubber cap

filip00

02-20-2025 08:11 AM

I did the same thing. Make sure not to center the hole, but go as high as possible towards the front of the car, as the struts are positioned more to the front, rather than in the center.

Regarding the size - the larger it is, the easier it will be for you to adjust. Find a cap first, then match the hole to the cap.

vtec to vvel

02-21-2025 10:53 PM

Quote:

Originally Posted by cooltoy (Post 4054303)

I don't think it matters what size you cut it. AS long as it is big or small enough for your needs.

[/URL]

This is when Michael from The Office pops into my head and says "That's what she said"

All times are GMT -5. The time now is 09:10 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page