I am absolutely in! Already have nav screen and wideband but definitely in

anyone fitted one of these yet with the oem nav unit looks great keen as

sub'd
this looks bad ***
:happydance:

any new updates?

^This! Would be great if there was an interface, cable, or some way to make the factory nav screen display obd2 readouts. Any info?

I love carbon signal but they never reply pms or instagram

I know they are working on the final setup and getting it ready as soon as possible. Also the different timezone makes the delay a bit longer. Cant wait to see it completed.

Yeah it's almost 1am in Dubai now.

Also bear in mind it's like Easter in Dubai here (Public Holidays)

It was put on hold for few weeks but we did post an update on first protytype on our FB page :)

http://i1124.photobucket.com/albums/...pskupgj432.jpg

http://i1124.photobucket.com/albums/...pszd0hapcj.jpg

Not a final one as there will be some revisions to the design in the coming days, one in the pic is with the joystick and airlift controller (not properly installed), Normal production one will have just the joystick.

We will offer an option of integrating any other air setup module or boost controller in the console as well. Hopefully design will be finalized by next week.

:tup:

We will look into at later stage as module can display anything with HDMI input which is not there we will see what can be done via RCA or AV port but for now it will be offered as above pic.


Im sorry but we do reply to pms on forum & FB along with emails and whatapps messages at earliest, we are looking at 15-25 messages (more on weekends) on each platform on daily basis so sometime we can miss here and there at times because of time difference and weekends on different days. I tried to dig in pms but couldn't find your message back till beginning of the year

Instagram it says clearly for ways to contact either email or whatsapp, phone call, cant send DMs to everyone and most of the time we cant see all comments for replying because only limited numbers are visible

I tried to dig in the pms here couldn't find from you from jan till now, please send it again and someone will tke care of it.

Looks way better than my sketches. Can the CS logo be centered somewhere?

Also, I believe the top part of the radio bezel is shaped differently for Bose and non-Bose (Base) trims.

looks great

It will be done first for Bose then altered for base model.

In a normal just joystick one logo and joystick are in middle.

Final design will have some more changes

Here's some ideas for a lower profile rotary encoder knob. See if this helps with the overall design especially center mounted. You may have to use a spacer to offset the rotary encoder or source a different one:
http://www.adafruit.com/images/970x7...G7UI6cXMfT.jpg
http://www.robot-italy.com/media/cat.../0/2055-02.jpg

Unfortunately, it'll be difficult to make space for a boost control module unless you put the rotary encoder on the extreme sides. Heck, maybe it can be an option with detachable face plates.

Wait for final design:tup:

We are using same rotatory knob its very nice quality and also feel (aluminium), as manage to install airlift and knob along with a decal plate so there is enough space. We did airlift as we are agents for it no so can offer else there will be knob just in middle and also without any holes so customer can install it where ever they like (syncro rev space in autos or between seat heaters) and use this space for boost turbo timer etc.