Ah f*** me if I can remember the numbers, I did it back in november. I forget because all my measurements were in mm, and I had to recalculate all specs I found online in inches, so I have no recollection of what were the numbers. I remember though, that it was in the middle of the spec - which was a relief, because I really wasn't feeling like trying to machine-guess the new shims to fit.
No worries. Time to take apart and disassemble to check backlash and measure again to ensure it is within specs. This time, write it down :tup:
filip00
04-17-2023 02:53 AM
Quote:
Originally Posted by vtec to vvel
(Post 4037901)
No worries. Time to take apart and disassemble to check backlash and measure again to ensure it is within specs. This time, write it down :tup:
Haha, not doing that again. Was within specs, works well, glad that saga is over :driving:
