Nissan 370Z Forum

Nissan 370Z Forum (http://www.the370z.com/)
-   Engine & Drivetrain (http://www.the370z.com/engine-drivetrain/)
-   -   Car won't turn on or off (http://www.the370z.com/engine-drivetrain/118124-car-wont-turn-off.html)

squid267 11-20-2016 03:42 PM

Car won't turn on or off
 
2012 370Z Nismo 6MT with a very odd issue.

I'm in the middle of a TT install, but the car started up successfully last week. Then I spent the week trying to get the lower joint coupler on the lower steering shaft and the front suspension back together.

Today, I go to turn the car on and it cranks but doesn't start. Also, I noticed that I didn't hear this fuel pump priming or gauges turn on. Lastly, I can't turn the car off. The light stays lit on the 'ON'. I gotta pull the negative terminal to turn it off so to speak.

Here's what I've tried
  • Jumping car
  • Booster pack
  • Replacing FOB battery
  • Trying spare key
  • fob in the fobgina.

Now, I'm just trying to get car ON so I can read codes with Ecutek. No luck. Everything results in same behavior. Car doesn't turn on, shows signs of dead battery. (Fuel pump not priming, gauges not turning on) Can't turn off car. Have to pull negative terminal.

I've googled around can't find anything. I thought maybe steering lock but the ignition light isn't on LOCK.

Attached are the lights I see.

http://i64.tinypic.com/16k5ds0.jpg

SouthArk370Z 11-20-2016 04:25 PM

You may have knocked the antenna that receives the fob signal in the console loose.

Try the fob in the fobgina.

squid267 11-20-2016 04:35 PM

Quote:

Originally Posted by SouthArk370Z (Post 3580183)
You may have knocked the antenna that receives the fob signal in the console loose.

Try the fob in the fobgina.

Tried that. still no luck. I'm starting to think I tripped the security system.

squid267 11-20-2016 04:49 PM

Additionally, my physical key isn't locking or unlocking the car.

SouthArk370Z 11-20-2016 05:49 PM

Quote:

Originally Posted by squid267 (Post 3580192)
Additionally, my physical key isn't locking or unlocking the car.

The door mechanism/electronics may have gone bad.

If nobody comes up with an answer, the FSM (link in my sig) has diagnostic procedures.

squid267 11-20-2016 07:25 PM

I was able to pull these codes with Ecutek. Based on the FSM and one other thread it sounds like my ECM/BCM might be kaput..

Performing DTC Operations on Nissan Body Control Module...
Reading DTCs...
U1000
U0415
B2191
B2193
B2553
B2557
B260A
B260F
C1729
9 DTCs Read
End of DTC Operations on Nissan Body Control Module...

SouthArk370Z 11-21-2016 05:49 AM

Check CAN wiring/connectors. You may have knocked something loose or cut a wire during the TT install. Fix the U1000 problem and the rest will probably disappear.

Funeralclown 11-23-2016 11:25 AM

Just read about this in a post from Zbakes:
http://www.the370z.com/nissan-370z-g...vage-370z.html

Maybe it'll help.

squid267 11-29-2016 08:32 AM

Quote:

Originally Posted by Funeralclown (Post 3581281)
Just read about this in a post from Zbakes:
http://www.the370z.com/nissan-370z-g...vage-370z.html

Maybe it'll help.

Thanks, it was good to read. I dropped the car off at the dealer yesterday.

Zaisersoze 05-01-2019 10:20 AM

I have a problem that resembles yours!
 
Hi squid--

I have almost the same problem and the dealer tried to give my 2014 370z back to me to say it didn't work. Could you please tell me what ended up being the problem with your car? Here's my post describing my problem:
http://www.the370z.com/nissan-370z-w...ml#post3848470http://www.the370z.com/nissan-370z-w...ml#post3848470

I would really appreciate any clues to what's going on.

Thanks


All times are GMT -5. The time now is 12:29 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2