Just dont take off too much once you get through the heat treat its junk nissan sells different sized lifters, the exhaust lifters are available and fit both intake and exhaust. Also remember to check them under full ladder assembly torque while bolted to the heads the clearances change a lot as you tourque it all down.
|
Quote:
Cams are there, bolting all back. Following all torque moments from user manual Will fire up an engine today-tomorrow. |
Quote:
|
I'm about a year in-half away from installing my top end build
|
Quote:
As of performance, only cams. Then oil cooler, racing thermostat, silicone lines, oil catch tank and something else |
Nice, im interested in seeing what gains you get from the install. What tuning software are you going to use? Are installing the jun 288?
|
Quote:
Originally I was going to use UpRev, but now seriously thinking of Ecutek. My last figure was - 300 hp with no software and major mods. Hope to see 320 hp on cams and soft |
awesome, can't wait to see the numbers
|
Quote:
Sure |
Cams installed, all good, no CE light, temps okey. Will drive to dealers to adjust idle.
|
Quote:
|
Quote:
Haha ) yep bro ) Crimea, sanctioned area |
Are there any tuners out there, particularly Ecutek?
|
Quote:
They're, going to use Uprev, because Ecutek isn't in stock |
Let us know how it goes. Did you have a baseline dyno form before installing the cams?
|
All times are GMT -5. The time now is 11:42 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2