Originally Posted by YzGyz (Post 3095368)

The video is a little Blair Witch but I'm doing it as I go. It's nothing special. Its a simplified run of removing the whatever is needed to be removed and swapped out. I'm not going to record the reinstall as that is just everything backwards. However, I might record the rundown of how I put the diff back into place as it may be tricky. Like I said, it's an easy job thus far. I will post it in the DIY and link it here after everything is done.

YzGyz

Originally Posted by dP3NGU1N (Post 3095496)

Do you even need to drop the diff to remove the cover?

Originally Posted by YzGyz (Post 3096495)

Here are the videos I made. I added them on to the old DIY thread so everything is in one place.

http://www.the370z.com/diy-section-d...-bushings.html

YzGyz

Originally Posted by chops (Post 3096563)

hmm...what podcast were you listening to? sounds like we are all we need in the background :tiphat:. good job on the videos

Originally Posted by rajmangal7 (Post 3096532)

Thank you!! I'm gonna use this Saturday.


-Raj

Originally Posted by YzGyz (Post 3096589)

I was streaming music off my phone that I plugged into my monitor speaker.

I usually stream Digitally Imported radio (DI.FM). They have lots of channels to choose from.

The music in my videos were YouTube streams of Above and Beyond Group Therapy.

YzGyz

Originally Posted by rajmangal7 (Post 3096666)

So you would still drop the driveshaft and axle for the differential cover?

Originally Posted by rajmangal7 (Post 3096666)

So you would still drop the driveshaft and axle for the differential cover?

Originally Posted by YzGyz (Post 3096747)

I was able to push the drive shaft to the side and then lower the end of differential then pry it out. I left the drive shafts in place. I recommend lifting the car up as high as possible (both front and back, not just the back like I did) to give you more room to work the saw, drill, pry bar.



YzGyz