https://uploads.tapatalk-cdn.com/201...7510eac81a.jpg little bit better pic


Sent from my iPhone using Tapatalk

DIY: How to Bleed Your Brake Fluid Using Motive Power Bleeder 0117 (AK370Z)
 

https://uploads.tapatalk-cdn.com/201...f3869cabd3.jpgtilted it down and **** stuck to the side here it is. Should I just stop and dump brake fluid cuz I'll need to get more and start another day


Sent from my iPhone using Tapatalk

I unhooked the cap from reservoir and I think I got whatever it was out but now I'm scared to keep goin what if there's other stuff in my apperantly clean lines that I cleaned with denatured alcohol that I will miss going into my reservoir


Sent from my iPhone using Tapatalk

I guess I will just keep goin and hopefully it'll be ok and I don't lose my brakes


Sent from my iPhone using Tapatalk

Ok so now I can't get the whole line to fill with fluid. Is that normal? I'm at almost 14psi and it's holding pressure. Will it just go when I open the bleeder? https://uploads.tapatalk-cdn.com/201...58fa3e80f3.jpg


Sent from my iPhone using Tapatalk

https://uploads.tapatalk-cdn.com/201...94caf23101.jpg https://uploads.tapatalk-cdn.com/201...af0ea161a3.jpg this is turning out to be way more difficult then it should be


Sent from my iPhone using Tapatalk

Now I can't get it to reach 14 psi. It's holding steady just where it is but won't go up any higher. And I can't get the lines to completely fill with fluid.


Sent from my iPhone using Tapatalk

If you're concerned about the contaminant, depressurize the system, disconnect the adapter tube and reflush with denatured alcohol. Should only take a few minutes including drying time.

Just bleed my brakes today with the Motive Power Brake Bleeder after the Z took a 6 month slumber. Instructions were great, I followed them step by step.

The Only hiccup was the brass connector between the main tube to the bleeder and the reservoir cap. It started leaking on me. Next time I'm going to add some silicone tape around it.

Thank you AK370Z!

Did this today using the red label Motive tool (cheaper one with the plastic adapter)... easy peasy. I loaded the container with 2qts, but I ended up only using one.

Now - where the heck can I find replacement bleeder caps? All of my outter ones were rotten or MIA.

Z1.
https://www.z1motorsports.com/brakes...p-p-12537.html

This is what I bought a few years ago.

https://www.ebay.com/itm/Allstar-Per...Uygp:rk:1:pf:0

Thanks guys - I went with what TreeSemdyZee bought since it was on Amazon Prime.

And unfortunately, shipping cost from Z1 probably would have been $20.00. :rofl2:

Didn't even think of looking there. Even cheaper. :tup: