this one has a voice recorder
HOMELINK ROLLING CODE transmitter WITH VOICE RECORDER colors TAN | eBay

I have a brown, grey and black.

Which one is constant and accessory?

Sorry for the dig, but I have a sily question about the homelink setup. Has anyone tried the homelink harness from a 350Z? I may just breakdown and go to the dealer otherwise. I have to pick up some interior panels as well.......and they are damned expensive!

Success!!! Thanks for the great write-up... Made the install super easy.:tup:

Just installed a Gentex 453 I bought on Ebay :) Thanks for the instructions! For that plastic tab holding the mirror on I just put a flathead screwdriver behind it, pulled it just a little towards me and the mirrior slid right up. I was dreading that part but it was easy.

Most of the pics are dead =(

.......And now all of them are dead =(
Just when I wanted to do this install!

Me too. :( Dang it.

The pics weren't all that necessary.. I was able to get the stock mirror off and run the wiring for the Gentex 453 pretty easily.

The stock mirror comes off as described. The A-Pillar comes off easily too - just grab the top and pull, it will come loose. Find the middle clip which is hooked in the pillar, turn the plastic ribbon 90 degrees with needle nose pliers to release it. Then, just pull the pillar up and out and it will come right out. From there you can just run the wiring down to the fuse box and tuck under the headliner and you are good to go!

The plastic finisher I got from Nissan appears to be generic and adjustable, I think you might as well buy a wiring kit off ebay that comes with the finisher.

Good luck!

you can tuck the wire behind the a-pillar cover without removing it. just pull down the weather stripping on the door jam side.
makes your job go much faster.

here, i even mentioned this 4yrs ago..lol

the only picture i needed was the one Mike posted how he tapped the wires on one of the DIY threads.

I ended up using a couple of those fused add-a-circuit taps to tap the fuse block. Used the "BOSE AMP" circuit for 12V Constant and "CIGAR LIGHTER" for 12V switched. The "BOSE AMP" circuit was there with a 20A fuse even though I have a base... and I assume "CIGAR LIGHTER" is the power port in the passenger foot well.

Installed!

http://www.the370z.com/members/jayho...er-compass.jpg

:tup: sure beats having a garage door opener on the visor.

http://www.the370z.com/diy-section-d...r-install.html

post #6 by Mike.