can only adjust to 2.5 with spc camber kit!!
 

Guys I'm at the shop right now. I installed my rear spc camber kit last night and toe bolt. The back was -3.6 and there saying they can only go to- 2.5. Wtf I want more positive camber. Advise

They can only go 2.5 because the arms would only give so much adjustments or was it because your car was slammed and needed the camber to avoid rubbing?

Why would you want to run 2.5 positive in the rear? -1.8 is suggested.. if you can't get more positive then -2.5 then they are doing it wrong unless your car is litterally on the ground and in that case your doing it wrong.

He's saying he wants less negative camber than -2.5. He wants to be around -1.8 but the SPC kit didn't allow them to get it any closer to stock than -2.5.

OP needs to be more specific with his wording. He's say he's stuck at 2.5 NOT -2.5 and said he wants more positive camber.

I wonder how slammed this car is and if not, what the problem is.

Do you have SPC arms or kinetex?

There's not an adjustable arm on the planet made for the Z34 that could get the rear to 2.5 degrees positive camber in the rear, especially if he was starting out -3+ before the install. Some assumptions are safe to make, guys.

you must be slammed then if -2.5 is the farthest the SPC arms will get you....... unless im missing something.

I'm curious too. I just installed the same thing last weekend and am getting ready for an alignment next week but from the looks of it, there were enough threads on the camber arms to push the wheels into positive camber. I didn't even bother with camber bolts either.

Arms say they have a 4 degree adjustment so sounds like the shop is failing miserably if -2.5 is as far is you can go.

I mean come on dude who runs 2.5... obviously its -2.5.

Yes the car is on its nuts. I wanna be -1.5.... help guys

The bolt hole on the chassis has to be elongated to get the full range of adjustment.

Do you have the camber arms as well as the bolts?

Yes and the did enlarge the toe bolt hole.... :/

Are you at advance performance? If not, you should be.

That's were I been going for two years now.

the only ones to touch my tires/susp

They do great work :) deff happy with there service. Just puzzled why I can't get more positive camber

Being random, but throwing it out there. If full spc camber range is dependent on their toe bolts, maybe holes aren't elongated enough?

I'm sure they are though but can't think of anything else.





Tapatalk2 ...

I am still confused why are you trying to get more then 2.5 positive?

2.5 negative, and wanting to add positive. Safe assumption.


Tapatalk2 ...

Because i want more traction and the look. I want to go more low but a certain look on the drop.

My rear camber is 2.1 and the toe is .14 and that is with SPC and coils. All done with elongating the toe bolts.

well idk the kit comes with that toe bolt plate so idk why the shop wouldnt drill off whats required.

My shop wouldn't touch it either...had to have a buddy at one of my Z meets do it.

what im saying is the Shop did drill it out, but i doubt they would screw it up since it comes with that plate.

What the OP needs are the ARMS, toe bolts only go so far!