BC coilovers adjustment ... Front
 

Need to lower it altitude bit in the front. Can somebody take some pics or tell me what to loosen up?

I'm doing this from memory so I might be a little bit off here...
Undo the bolt holding your brake line to the coilover bracket, slip off the 3-4 rubber grommets holding those other lines.
Loosen up the lower locking ring using your spanner wrench. Then using their the larger or smaller spanner wrench, depnding on the direction you are turning, turn the locking rings up top either left or right. When doing this, making sure you are turning only one ring or else you can loosen up the two locking rings and it'll adjust the pre-load. You basically want to turn it so the rings stay against each other and not loosen up, and that'll turn the entire coilover unit.

To lower the fronts its super easy.... Just undo the lower gold ring (the one that stands by itself) DO NOT undo the 2 gold rings on the top as BC has set the preload already....

To adjust all you do is spin the bottom fork piece clockwise for lowering, counter clockwise for raising... You will see how it get shorter or longer when you start spinning it.

I've installed these specific coilovers 8 times, very easy to adjust :)