Vipor is on it today.

I have about a finger gap all around. If I spin my exhaust bolts so that the bolt is sticking towards the ground I scrape on everything...and thats like maybe an inch to 1.5inch lower than the rest of the car. If I drive around with tires on trackday pressure settings, I scrape going into my garage, at 35psi, no scrape.

1 finger wheel gap? do you know in inches how much lower you are? i am going to get coilovers and drop an inch, so i'm just curious, will i have clearance issues with this brace?

have fun on speed bumps :tup:

with the brace or in general? I hate how they made this car so low, but with so much wheel gap. they make it such a dilemma to lower the car.

20" rims?

what about them? Mine are 19"

It does :shakes head:

I'm gonna build some 2x10 ramps before my next oil change so I can get my floor jack under my car more easily..

I recommend 2x12's. I have a pair of 3' segments with 45 degree mitre cuts at the end I wedge under the front tires before pulling forward and jacking up my front end. The true size of a 2x10 is 9 1/4", which isn't wide enough to fully span a 245mm (9.65 inches) tire. I pushed my compound mitre saw (dual sliding 10") to the limit though doing a cut like that on a 2x12 (11 1/4").

:iagree:

They were so helpful with my Z. Saved me a few hundred bucks on buying a long-neck, low profile jack. :tup:

/subscribe. thanks :D

You wanted less wheel gap without dropping the car on coilovers. Bigger rims is the answer. Hell, get 22"s!

hahah, yea you gotta think outside the Box sometimes!
http://www.the370z.com/members/jeffb...38-photo-4.jpg

dont hate man his pimpin

Still wish it was orange lol.