370z Airlift 3H sensor installation
 

Hey guys!

Finally took the plunge to give air ride a shot!! All my equipment has been purchased and arrived. Just going through the planning phase and wanted to ask some of you experts out there for your ideas.

1. For those of you using Airlift's 3H system, where did you mount the height sensors for your rear suspension? Any pics?
2. I've stripped my rear hatch looking for grommets I can take advantage of to get lines outside, but they all seem to end up either near the rear diff or close to an exhaust pipe or heat shield. How are you air lines exiting your cabin?
3. Did you run all your airlines outside then ran front lines under the chassis to the front struts? Or did you run them inside the cabin then into the engine bay?

Spread the knowledge!!!
Thanks guys!