Nissan 370Z Forum - Noise coming from Endlinks

Page 2 of 2

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Brakes & Suspension (http://www.the370z.com/brakes-suspension/)

- - Noise coming from Endlinks (http://www.the370z.com/brakes-suspension/134249-noise-coming-endlinks.html)

k67p67

02-21-2021 04:28 PM

The conical aluminum spacers belong on the sway bar end of the endlink.

From SPL site:
https://cdn10.bigcommerce.com/s-xn4b...0.1280.jpg?c=2

ZoomZ

02-21-2021 04:50 PM

1 Attachment(s)

Quote:

Originally Posted by k67p67 (Post 3986430)

The conical aluminum spacers belong on the sway bar end of the endlink.

From SPL site:
https://cdn10.bigcommerce.com/s-xn4b...0.1280.jpg?c=2

Interesting. 2018 SPL install seems to contradict itself in steps 3 and 4. Looking at your image, seems that the angle at the control arm end is not Perpendicular, and is in fact putting an unwanted twist to rod-end. Would make sense to put spacer there to alleviate that. According to image.

Attachment 146305

k67p67

02-22-2021 04:14 PM

Hard to say without seeing the end of that sway bar. There may be some preload causing the endlink to rotate off center.

Quicksilvers

02-23-2021 08:16 AM

Quote:

Originally Posted by Rusty (Post 3945395)

Get them to wrap the teflon thread tape around the swaybar.

If you are adding grease to your sway bar make sure if is synthetic grease and not regular grease. I too had a noise coming from my front sway bar and since grease would not work I applied the teflon threaded tape and it can work and take the unwanted noise away if done right.

Quicksilvers

02-23-2021 08:19 AM

1 Attachment(s)

Use a synthetic grease like this.

All times are GMT -5. The time now is 02:19 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page