Nissan 370Z Forum - Competitors to KW V3 and who ran Greddy X KW

Page 8 of 8

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Brakes & Suspension (http://www.the370z.com/brakes-suspension/)

- - Competitors to KW V3 and who ran Greddy X KW (http://www.the370z.com/brakes-suspension/130579-competitors-kw-v3-who-ran-greddy-x-kw.html)

Rusty

06-07-2019 11:17 PM

Quote:

Originally Posted by SPDKING (Post 3858896)

There is a plate/bracket in the front suspension connecting the lower control arm (I think?) to the front brakes and the coilovers that are hard as hell to get off when I tried to switch from the stock dampers to the Koni dampers.

:icon14: I didn't have any problems with that. :rofl2: Of course my bag of tricks is pretty deep. :tup:

SPDKING

06-08-2019 01:18 AM

Quote:

Originally Posted by Rusty (Post 3858953)

WD40 isn't very good for rusted nuts and that. There is a lot better out there. I use Blaster PB.

I will make sure I pick that up with a breaker bar tomorrow. Anything else that might make this install easy? Lol I'm close to getting an impact wrench. I'll post pics of the install if I get around to it this weekend.

SPDKING

06-08-2019 09:59 PM

No longer a virgin got my Annex coilovers installed on the fronts. Will be doing the rear tomorrow and adjust the height because it is nervously low where I did not want to attempt leaving my garage. Why the f*** the manufacturers always give them to mmediately low out the box? So annoying to adjust and pre load

All times are GMT -5. The time now is 08:45 AM.

Page 8 of 8

« First

Show 40 post(s) from this thread on one page