Nissan 370Z Forum - 370Z ZSpeed Undershroud Group Buy

Page 2 of 2

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Body Interior/Exterior (http://www.the370z.com/body-interior-exterior/)

- - 370Z ZSpeed Undershroud Group Buy (http://www.the370z.com/body-interior-exterior/29437-370z-zspeed-undershroud-group-buy.html)

SPOHN

03-06-2011 08:00 PM

Quote:

Originally Posted by Mike (Post 972733)

it slightly interferes with my oil cooler fitting, but not enough that I couldn't attach it. Its just bowed out a little right where the lines come down. They are hard fitting though , and it shouldn't be a problem, but I may just cut the area out to be safe.

So is the oil cooler upside down?

And how was your track day being it rained?

Mike	03-06-2011 09:40 PM

no, my sandwich plate is oriented so the fittings are on the bottom.

today was awesome, after the first session, which was wetter than anything yesterday. three really good sessions in the dry.

SPOHN

03-06-2011 09:49 PM

Quote:

Originally Posted by Mike (Post 973038)

no, my sandwich plate is oriented so the fittings are on the bottom.

today was awesome, after the first session, which was wetter than anything yesterday. three really good sessions in the dry.

Then if that's the case. Would that be where the trap door is?

I'm going to install my GTM oil cooler tomorrow. Any suggestions of what angle I should put the sandwich plate in? Such as the fittings facing more of the front of the car or more towards the ground.

All times are GMT -5. The time now is 04:05 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page