Car wiring harness question
To start with
Base system Pioneer F900BT Peripheral PESWIPS steering wheel controls I stole this from another thread http://www.the370z.com/attachments/a...s-non-bose.png Now, My Metra harness adapter only has wires at pin locations 2,3,4,5,10,11,12,13,14,16,18, 19 and 20, so most won't line up with the factory stuff. The Peripheral PESWIPS steering wheel interface for pioneer says I need to tap into 6 and 15, but the harness adapter has no wires there. Does anyone know an easy way to remove the wires I don't need from the harness and relocate them? At a minimum, I just ordered a scosche harness, although it looks the same, but I can at least destroy the molex connector to harvest the wires and pins if needed. Or am I just missing something obvious? |
harvesting the pins is one idea, or you can just shave a bit of insulation off of the factory side of the harness and connect your PAC-SWI-PS there.
|
Quote:
|
are you looking at the connector from the right side? im using the exact steering wheel remote adapter thingie and scoche connector and it's working fine on my 3100.
|
Quote:
|
All times are GMT -5. The time now is 11:12 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2