They may no longer exist. The post you are referencing will be 4 years old next week.

damn....maybe you can help lol
attached an image for the power mirror clip thing...dunno where the red and black tips need to go into...

I'll do my best, though I am not using an invisicord. Do you have a multimeter?

Most likely the black wire is ground. From there, figure out which wire is switched power (i.e. +12V when the ignition is in the on position). Once you've confirmed those two wires, jam the invisicord wires into those slots and you should be good to go?

If you don't have a multimeter, go get a cheap one from Harbor Freight or something. It's an extremely valuable tool to have.

Don't you have the 2014 service manual?
The wiring diagrams are in there with the proper color codes.

I suggest you find the free downloads site and then get to work.

Looking it up as we speak lol

did you take out the existing wires and insert the invisicord then place them back in?

and you just saved me a bunch of time! :D

I just pushed the ends in, but I think I bought the mirror tap brand, so maybe the ends are skinnier.